Hello,
It is possible to change the active document using Ctrl+Tab while a long-running task is active. Doing so has caused an infinite loop using full CPU resources. This was initially done inadvertently as I was rushing and thought the command had completed.
Example:
Open multiple documents with many layers and entities.
Run ISOLATE to isolate layers.
Run RESTORE to restore the layer visibility.
While RESTORE is running hit Ctrl+Tab to change the active document.
The CPU usage should remain high.
Update:
After testing it again the restore layers did complete after many minutes. Several orders of magnitude longer at full CPU than if the active document did not change.
Intellicad version 7.1.1644.53233.P
The purpose of this forum is to create the communication channel between developers of Carlson with IntelliCAD engine and the end-users.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.