New Carlson 2023 / IntelliCAD 10.1a and 11.0 build (230319) is posted

New Carlson 2023 / IntelliCAD 10.1a and 11.0 build (230319) is now available for testing.

Following issues were resolved:

IntelliCAD 10.1a:

• A block tool created on the Tool Palette shows default properties
• Printers initialization hangs in case of printer connection problem
• Feedback details log misses some strings that could facilitate debugging
• Missing support of MG4 MrSID multispectral images (with more than 4 bands)

IntelliCAD 11.0:

• Some command prompts are missing
• An error message is needed if insert an XREF while the block with the same name as XREF is created
• Printers initialization hangs in case of printer connection problem
• Missing support of MG4 MrSID multispectral images (with more that 4 bands)
• Feedback details log misses some strings that could facilitate debugging
• Data from different profiles may be mixed up

Please let us know if you encounter any issue which will have to be fixed immediately or other issues which are new.

As always, if this build is problematic, a full official install can be used to restore.

Thank you,
Leonid

New Carlson 2023 / IntelliCAD 10.1a and 11.0 build (230303) is posted

New Carlson 2023 / IntelliCAD 10.1a and 11.0 build (230303) is now available for testing.

Following issues were resolved:

IntelliCAD 10.1a:

• DGN Group code 66 not set for INSERT
• The coordinates controlled by INPUTECHOFLAGS should show Z value
• Status bar should display correct coordinates when switching between snap points using TAB
• Some freezes of OPENIMAGE command
• Some crashes

IntelliCAD 11.0:

• Getting then setting HPCOLOR or HPBACKGROUNDCOLOR fails in DGN mode
• Object is not displayed even if undo is executed after LAYDEL command
• Some errors in table style implementation for datalinks
• Row height value of a table may change spontaneously
• "Insert Table" dialog: error message should not appear on cancel
• Status bar should display correct coordinates when switching between snap points using TAB
• DGN Group code 66 not set for INSERT
• The coordinates controlled by INPUTECHOFLAGS should show Z value
• Some freezes of OPENIMAGE command
• Some crashes

Please let us know if you encounter any issue which will have to be fixed immediately or other issues which are new.

As always, if this build is problematic, a full official install can be used to restore.

Thank you,
Leonid