New Carlson 2025 / IntelliCAD 12.1 and 11.1 build (250220) is now available for testing.
Following issues were resolved:
IntelliCAD 12.1:
The polyline is not extended in the DGN drawing.
Editing text is causing MLeaders to move.
Incorrect behavior when attempting to use incorrect value for the GRIPDYNCOLOR sysvar.
getpoint handles string wrong.
Qselect Alert message issue.
BMPOUT command is added to DGN mode.
Saving to a remote location failed.
Switch focus (Properties Panel & drawing area).
After selecting the text, text editing using the [Properties] pane proceeds differently from AutoCAD.
Incorrect selection with the TRIm command and using the SHIFT key to use EXTEND.
MLeader dogleg is rotated when USEVIEWTWIST=1.
Mleader moves when editing if USEVIEWTWIST=ON.
Mleaders COLLECT issues.
Some styles are displayed incorrectly in metric drawing.
Table text gets huge.
IntelliCAD 11.1:
- n/a
Please let us know if you encounter any issue which will have to be fixed immediately or other issues which are new.
As always, if this build is problematic, a full official install can be used to restore.
Thank you,
Leonid
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.