New Carlson 2025 / IntelliCAD 12.1 and 11.1 build (250212) is now available for testing.
Following issues were resolved:
IntelliCAD 12.1:
Erroneous placement of ref images when printing.
Palettes using externally referenced palette files are not added correctly.
Ribbon state is not retained for the dgn drawing after RIBBONCLOSE command.
-VIEW command is missing in DGN mode.
Single entity selection does not work in the drawing in DGN mode.
IntelliCAD 11.1:
- n/a
Please let us know if you encounter any issue which will have to be fixed immediately or other issues which are new.
As always, if this build is problematic, a full official install can be used to restore.
Thank you,
Leonid
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.