New Carlson 2025 / IntelliCAD 12.1 and 11.1 build (241127) is now available for testing.
Following issues were resolved:
IntelliCAD 12.1:
(entget (car (entsel))) doesn't work for XREF in DGN mode.
grdraw doesn't work on DGN file.
Geotiff image is not in the expected position.
Unable to change an existing Xref Path from absolute to relative.
Copies of the advanced block vanishing.
Layer Delete Errors in DGN mode.
INVALID KEY message on command line after copying the two horizontal lines.
-layer thaw is unjustifiedly slow in DGN mode.
Changed behavior of sysvar RTDISPLAY.
The effect of the HIDE command was removed after changing the object or changing the display.
Solids model view changed by View Cube much slower than view changes via the ribbon.
IntelliCAD 11.1:
- Crash after selecting polylines in DGN mode
Please let us know if you encounter any issue which will have to be fixed immediately or other issues which are new.
As always, if this build is problematic, a full official install can be used to restore.
Thank you,
Leonid
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.